Indoor medical cropping

CULTIVATION GUIDE

Adaptation to indoor

Germination of our seeds:We have two germination options, on one side we germinate in a glass, in this modality we spill the seeds in a small glass with cold water (around 10Cº), this will increase the oxygen content in the water and will improve the germination, also we can germinate with 20Cº Water adding a drop of oxygenated water.

The other option is to place the seeds on a plate surrounded in a napkin of kitchen paper, we soak it with water without flooding the plate, in this case the water temperature does not concern as much as the atmospheres temperature which is optimal between 22 and 24Cº.

Once it shows the first little root the seeds must be taken out of the germination glass and plant them into earth, Coco or rockwool with high humidity and vegetative period of 20 hours.

Growing phase:

In the growing phase, we will maintain the plants with a photoperiod of 18-20 hours under illumination equipment of 600 W, being able to use a growth and flowering spectrum or only growth. The growing phase will approximately last for a month (If we are using clones) depending on the variety and month and a half if we start with seeds. The PH level should be round 6.

For root expansion we recommend to irrigate 3 times per week with organic products (ORGANIK ROOT ENHANCER) applied during the first two weeks with a dosage of 1 ml/l. In these two weeks the plants will expand roots and will be prepared to confront a vigorous vegetative growth.

For the vegetative growth we used an organic product (ORGANIK GROW), with two irrigations per week fertilizing with a dose of 3-5 ml/l and irrigating in between to avoid the accumulation of salts in the substrate. This will give vigour and expansion of beautiful foliage that prepares the plant for a maximum of productivity and psychoactivity.

Blooming phase:

Once the month is over and the plants are about 50 cm high (only indoor), we come to enjoy the real cannabis essence, changing its photoperiod to 12 hours (always remember 600 w flowering spectrum only). The first week the plant will begin to adapt to the changes altering its hormones and dedicates itself to produce flowers and resin. The whole stage can last about 60 days (on the average), and we will concentrate the first month to flower productivity, the second month to the biosynthesis of resin, medicinal and aromatic compounds.

After the first month, the recommended organic product (ORGANIK BLOOM), is used with two irrigations per week having to irrigate in between with water to avoid the accumulation of salts. The proposed dose of 3-5 ml/l is perfect for the plant to develop its maximum production. (PH of 6,5)

It is always advisable to use some anti-fungal product, and preventive ecological mite killer to avoid the appearance of plagues since it is better to prevent than to cure, if some plague settles it is very difficult to make it disappear until using toxic chemical insecticide products.

After the first month, we will concentrate in the resin production, so that we will use an irrigation per week of ORGANIK BLOOM with a propose dose and two irrigations per week of ORGANIK THC ENHANCER which is going to provide the basic pillars for the synthesis of cannabinoids.

The last week we are going to clean the earth of salts, watering with distilled water (with a low EC). The cannabis will be ready to cut and we will be able to enjoy plants with high productions and powerful psychoactivities, of a pleasant flavour and natural aromas.